Difference between revisions of "Mindmotion Mini-F5233-MM32F5233D7P"
(→SETUP) |
(→Preparing for J-Link) |
||
| Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_connect|400px]] |
+ | [[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 08:38, 7 September 2023
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
Minimum requirements
- J-Link software V7.92d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN1)
- Power the board via USB-C (CN7)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92d
- Embedded Studio: V7.30
- Hardware: MindMotion Mini-F5233 MM32F5233D7P
- Link: File:MindMotion MM32F5233 TestProject ES 7V20.zip
