Difference between revisions of "MindMotion MB-083-Mini-F5333"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the MindMotion MB-083 Mini-5333 evaluation board. 450px == Minimu...")
 
(→‎Minimum requirements)
(2 intermediate revisions by the same user not shown)
Line 3: Line 3:
 
This article describes specifics for the MindMotion MB-083 Mini-5333 evaluation board.
  
This article describes specifics for the MindMotion MB-083 Mini-5333 evaluation board.
   
−
[[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_board.jpg|450px]]
 +
[[File:MindMotion_MB-083-Mini-F5333_MM32F5333D7PV_board.jpg|450px]]
   
 
== Minimum requirements ==
  
== Minimum requirements ==
−
* J-Link software V7.92d or later
 +
* J-Link software V7.92e or later
   
 
== Preparing for J-Link ==
  
== Preparing for J-Link ==
−
*Connect the J-Link to the SWD header (CN1)
 +
*Connect the J-Link to the SWD header (CN5)
−
*Power the board via USB-C (CN7)
 +
*Power the board via USB-C (CN2)
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
   
−
[[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_connect.png|400px]]
 +
[[File:MindMotion_MB-083-Mini-F5333_MM32F5333D7PV_connect.png|400px]]
   
 
== Example Project==
  
== Example Project==

Revision as of 13:37, 7 September 2023

This article describes specifics for the MindMotion MB-083 Mini-5333 evaluation board.

450px

Minimum requirements

  • J-Link software V7.92e or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (CN5)
  • Power the board via USB-C (CN2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MindMotion MB-083-Mini-F5333 MM32F5333D7PV connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-083 Mini-5333.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=MindMotion_MB-083-Mini-F5333&oldid=16226"