Difference between revisions of "ESWIN ECR2560 FULLMASK 40PIN EVK"
| Line 2: | Line 2: | ||
This article describes specifics for the ''ECR2560 FULLMASK 40PIN EVK'' evaluation board.<br> |
This article describes specifics for the ''ECR2560 FULLMASK 40PIN EVK'' evaluation board.<br> |
||
| − | [[File: |
+ | [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Revision as of 10:16, 28 September 2023
This article describes specifics for the ECR2560 FULLMASK 40PIN EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J18.
- Power the board via 13.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN ECR2560 FULLMASK 40PIN EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V7.20
- Hardware: ESWIN ECR2560 FULLMASK 40PIN EVK
- Link: File:ESWIN ECR2560 FULLMASK 40PIN EVK ECR2560 TestProject ES 7V20.zip
