Difference between revisions of "ESWIN ECR2560 FULLMASK 40PIN EVK"
(Created page with "__TOC__ This article describes specifics for the ''ECR2560 FULLMASK 40PIN EVK'' evaluation board.<br> 450px == Prepar...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
This article describes specifics for the ''ECR2560 FULLMASK 40PIN EVK'' evaluation board.<br> |
This article describes specifics for the ''ECR2560 FULLMASK 40PIN EVK'' evaluation board.<br> |
||
− | [[File: |
+ | [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to J18. |
− | *Power the board via |
+ | *Power the board via 13. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN ECR2560 FULLMASK 40PIN EVK.<br> |
+ | It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.67c |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: ESWIN |
+ | *Hardware: ESWIN ECR2560 FULLMASK 40PIN EVK |
− | *Link: [[File: |
+ | *Link: [[File:ESWIN_ECR2560_FULLMASK_40PIN_EVK_ECR2560_TestProject_ES_7V20.zip]] |
Revision as of 10:17, 28 September 2023
This article describes specifics for the ECR2560 FULLMASK 40PIN EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to J18.
- Power the board via 13.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN ECR2560 FULLMASK 40PIN EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V7.20
- Hardware: ESWIN ECR2560 FULLMASK 40PIN EVK
- Link: File:ESWIN ECR2560 FULLMASK 40PIN EVK ECR2560 TestProject ES 7V20.zip