Difference between revisions of "Renesas EK-RA8M1"
(Created page with "__TOC__ This article describes specifics for the [SiliconVendor] [EvalBoardName] evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Prepar...") |
|||
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the |
+ | This article describes specifics for the Renesas EK-RA8M1 evaluation board. For device specifics, please see [[Renesas RA8M1]].<br> |
+ | [[File:Renesas_EK-RA8M1.jpg|450px]] |
||
− | '''[PICTURE OF BOARD]''' |
||
− | [[File:VENDOR_BOARDNAME.jpg|450px]] |
||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | * |
+ | *Power the board via J10 (Micro USB) |
− | *Power the board via........ |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
+ | [[File:Renesas_EK-RA8M1_CONNECT.PNG|400px]] |
||
− | '''[PICTURE OF CONNECT]''' |
||
− | [[File:VENDOR_DEVICE_CONNECT.PNG|400px]] |
||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA8M1.<br>It is a simple counter linked into the internal code flash.<br> |
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.92l |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: |
+ | *Hardware: Renesas EK-RA8M1 |
− | *Link: [[File: |
+ | *Link: [[File:Renesas_EK-RA8M1_TestProject_ES_V720.zip]] |
Revision as of 16:28, 25 October 2023
This article describes specifics for the Renesas EK-RA8M1 evaluation board. For device specifics, please see Renesas RA8M1.
Preparing for J-Link
- Power the board via J10 (Micro USB)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA8M1.
It is a simple counter linked into the internal code flash.
SETUP
- J-Link software: V7.92l
- Embedded Studio: V7.20
- Hardware: Renesas EK-RA8M1
- Link: File:Renesas EK-RA8M1 TestProject ES V720.zip