Difference between revisions of "NXP MCX-N9XX-BRK"
Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
− | This article describes specifics for the NXP MCX-N9XX- |
+ | This article describes specifics for the NXP MCX-N9XX-BRK evaluation board.<br> |
− | [[File: |
+ | [[File:NXP_MCX-N9XX-BRK_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to J4. |
− | *Power the board via |
+ | *Power the board via USB J3. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:NXP_MCX-N9XX-BRK_connect.png|400px]] |
== Example Project== |
== Example Project== |
Revision as of 16:16, 15 December 2023
This article describes specifics for the NXP MCX-N9XX-BRK evaluation board.
Preparing for J-Link
- Connect the J-Link to J4.
- Power the board via USB J3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-N9XX-BRK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V6.34
- Hardware: NXP MCX-N9XX-BRK
- Link: File:NXP MCXN947 TestProject ES V634.zip