Difference between revisions of "NXP MCX-N9XX-BRK"

From SEGGER Wiki
Jump to: navigation, search
Line 1: Line 1:
 
__TOC__
  
__TOC__
   
−
This article describes specifics for the NXP MCX-N9XX-BRK7 evaluation board.<br>
 +
This article describes specifics for the NXP MCX-N9XX-BRK evaluation board.<br>
−
[[File:NXP_FRDM-MCXN947_board.jpg|450px]]
 +
[[File:NXP_MCX-N9XX-BRK_board.jpg|450px]]
   
 
== Preparing for J-Link ==
  
== Preparing for J-Link ==
−
*Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
 +
*Connect the J-Link to J4.
−
*Power the board via J5,J27,J28 (depending on setting of J26)
 +
*Power the board via USB J3.
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
−
[[File:NXP_FRDM-MCXN947_connect.png|400px]]
 +
[[File:NXP_MCX-N9XX-BRK_connect.png|400px]]
   
 
== Example Project==
  
== Example Project==

Revision as of 16:16, 15 December 2023

This article describes specifics for the NXP MCX-N9XX-BRK evaluation board.
NXP MCX-N9XX-BRK board.jpg

Preparing for J-Link

  • Connect the J-Link to J4.
  • Power the board via USB J3.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-N9XX-BRK.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_MCX-N9XX-BRK&oldid=17305"