Difference between revisions of "NXP MCIMX7ULP-EVK"
(Created page with "__TOC__ This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link...") |
(No difference)
|
Revision as of 17:28, 8 March 2024
This article describes specifics for the NXP MCIMX7ULP-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to the 20 pin JTAG connector (J6)
- Power the board via 5V power jack (P1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCIMX7ULP-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: NXP MCIMX7ULP-EVK
- Link: File:NXP MCIMX7ULP-EVK TestProject ES V810b.zip
