Difference between revisions of "GigaDevice GD32103E-EVAL"
Line 2: | Line 2: | ||
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.<br> |
||
− | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg| |
+ | [[File:GigaDevice_GD32103E-EVAL_GD32F103ZE_picture.jpg|440px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
Revision as of 14:20, 5 April 2024
This article describes specifics for the GigaDevice GD32103E-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via CN2.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32103E-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32103E-EVAL
- Link: File:GigaDevice GD32F103VC TestProject ES V810b.zip