Difference between revisions of "ST SR6PX-EVBC4000P"
(→Preparing for J-Link) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 8: | Line 9: | ||
*Power the board via J1 (12V). |
*Power the board via J1 (12V). |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File: |
+ | [[File:ST_SR6PX-EVBC4000P_SR6P3C4_connect.png|400px]] |
Latest revision as of 11:29, 15 May 2024
Contents
This article describes specifics for the ST SR6PX-EVBC4000P evaluation board.
Preparing for J-Link
- Connect the J-Link to P1.
- Power the board via J1 (12V).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
