Difference between revisions of "ST NUCLEO-F042K6"
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 18: | Line 19: | ||
*J-Link software: V7.90 |
*J-Link software: V7.90 |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
| − | *Hardware: ST NUCLEO- |
+ | *Hardware: ST NUCLEO-F042K6 |
| − | *Link: [[File:.zip]] |
+ | *Link: [[File:STM32F04K6_Projekt.zip]] |
Latest revision as of 11:30, 15 May 2024
This article describes specifics for the ST NUCLEO-F042K6 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F042K6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F042K6
- Link: File:STM32F04K6 Projekt.zip
