Difference between revisions of "NXP PN640 Perf Board"
(Created page with "__TOC__ This article describes specifics for the NXP PN640 Performance evaluation board.<br> 450px == Preparing for J-L...") |
|||
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 11: | Line 12: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP PN640 Performance Board.<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.92g |
*J-Link software: V7.92g |
Latest revision as of 13:20, 15 May 2024
This article describes specifics for the NXP PN640 Performance evaluation board.
Preparing for J-Link
- Connect the J-Link to J25
- Power the board via Main USB.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP PN640 Performance Board.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92g
- Embedded Studio: V7.20
- Hardware: NXP PN640 Performance Board
- Link: File:NXP PN640 Perf Board V1.2 PN7362AU TestProject ES 7V20.zip