Difference between revisions of "GigaDevice GD32103C-START"
(→Preparing for J-Link) |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 14:25, 15 May 2024
This article describes specifics for the GigaDevice GD32103C-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP5 | 19 | +3V3 |
GND | JP6 | 1 | GND |
TMS/SWDIO | JP6 | 40 | PA13 |
TCK/SWCLK | JP5 | 37 | PA14 |
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32103C-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32103C-START
- Link: File:GigaDevice GD32F103VC TestProject ES V810b.zip