Difference between revisions of "MindMotion Mini-A0144"

From SEGGER Wiki
Jump to: navigation, search
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
  +
[[Category:Evalboards]]
 
__TOC__
 
__TOC__
   
Line 6: Line 7:
   
 
== Preparing for J-Link ==
 
== Preparing for J-Link ==
*Connect the J-Link to CN7.
+
*Connect the J-Link to CN2.
 
*Power the board via CN1.
 
*Power the board via CN1.
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:

Latest revision as of 15:11, 15 May 2024

This article describes specifics for the MindMotion Mini-A0144 evaluation board.
[PICTURE OF BOARD] 450px

Preparing for J-Link

  • Connect the J-Link to CN2.
  • Power the board via CN1.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MindMotion Mini-A0144 MM32A0144C6PM connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-A0144 .
It is a simple Hello World sample linked into the internal flash.

SETUP