Difference between revisions of "MindMotion MB-083-Mini-F5333"
(→Preparing for J-Link) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 6: | Line 7: | ||
== Minimum requirements == |
== Minimum requirements == |
||
| − | * J-Link software V7. |
+ | * J-Link software V7.92e or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Latest revision as of 15:11, 15 May 2024
This article describes specifics for the MindMotion MB-083 Mini-5333 evaluation board.
Minimum requirements
- J-Link software V7.92e or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN5)
- Power the board via USB-C (CN2)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-083 Mini-5333.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92e
- Embedded Studio: V7.20
- Hardware: MindMotion MB-083 Mini-5333
- Link: File:MindMotion MB-083-Mini-F5333 MM32F5333D7QV TestProject ES 7V20.zip
