Difference between revisions of "NXP NCJ29D5"
(→Internal Flash) |
(→Radio Configurations) |
||
Line 25: | Line 25: | ||
====Radio Configurations==== |
====Radio Configurations==== |
||
− | While RX radio configurations can be updated individually, TX radio configurations |
+ | While RX radio configurations can be updated individually, TX radio configurations can only be updated in a set of 2. |
==Watchdog Handling== |
==Watchdog Handling== |
Revision as of 11:53, 16 May 2024
The NXP NCJ29D5 are Ultra-Wideband (UWB) ICs designed specifically to meet the connectivity and safety needs of the global automotive industry.
Contents
Flash Banks
Internal Flash
Flash Bank | Base address | Size | J-Link Support |
---|---|---|---|
Normal-Domain Application | 0x00200000 | 128 KB | |
RX Radio Configurations | 0x00238A00 | 8 KB | |
TX Radio Configurations | 0x0023AA00 | 4 KB | |
Customer Configuration Page | 0x0023C000 | 512 B | |
Baseband DSP Firmware | 0x00230000 | 35 KB |
ECC Flash
- Device has ECC flash, reading of un-programmed or erased areas will result in an error.
- Dedicated verify and blank check functions are implemented.
Radio Configurations
While RX radio configurations can be updated individually, TX radio configurations can only be updated in a set of 2.
Watchdog Handling
- The device has a watchdog which is enabled by default after Reset with 20s timeout.
- On connect, the reset source of the watchdog will be disabled, so it keeps running, but doesn't force a reset.
Attach
- Attach is supported.
Device Specific Handling
Reset
- The devices uses normal Cortex-M reset.
- After Reset Watchdog is disabled as described above.
Evaluation Boards
- NXP NCJ29D5 UWB Shield Board V4 evaluation board: NXP LID2435
Example Application
- NXP NCJ29D5 UWB Shield Board V4 evaluation board: NXP LID2435#Example Project