Difference between revisions of "ncoder N4 board"
(Created page with "__TOC__ This article describes specifics for the ncoder N4 evaluation board. 450px == Minimum requirements == * J-Link software V7.70d or late...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 12:08, 16 May 2024
This article describes specifics for the ncoder N4 evaluation board.
Minimum requirements
- J-Link software V7.70d or later
Preparing for J-Link
- Connect the J-Link to the pins as seen in the image/table below:
Cable | JTAG-Pin |
---|---|
Red | 3.3V |
Blue | TDIO |
Black | GND |
Yellow | TCK |
Green | RESET |
Note:
For device reset to work as intended, RESET pin must be connected
For device reset to work as intended, RESET pin must be connected
- Power the board via usb power supply
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ncoder N4 evaluation board. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.70d
- Embedded Studio: V6.22a
- Hardware: ncoder N4 evaluation board
- Link: File:ncoder N4 evalboard TestProject ES V622a.zip