Difference between revisions of "GigaDevice GD32450I-EVAL"
(Created page with "Category:Evalboards __TOC__ This article describes specifics for the GigaDevice GD32450I-EVAL evaluation board.<br> File:GigaDevice_GD32450I-EVAL_GD32F450IK_picture.jpg...") |
(No difference)
|
Revision as of 16:31, 31 May 2024
This article describes specifics for the GigaDevice GD32450I-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32450I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32450I-EVAL
- Link: File:GigaDevice GD32F450IK TestProject ES V810b.zip
