Difference between revisions of "NXP MCIMX93-EVK"
(Created page with "Category:Evalboards __TOC__ This article describes specifics for the NXP MCIMX93-EVK evaluation board.<br> 450px == Preparing for J-Li...") |
(No difference)
|
Latest revision as of 16:11, 6 June 2024
This article describes specifics for the NXP MCIMX93-EVK evaluation board.
Preparing for J-Link
- Connect the J-Link to JTAG connector (J1405).
- Connect the onboard USB-UART debug interface to host computer (J1401).
- Open a serial interface communication via terminal application (PuTTY).
- Power the board via USB Type-C Power connector (J301).
- Turn on the power switch (SW301).
- Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Cortex-M33 connection:
- Cortex-A55 connection:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCIMX93-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10
- Hardware: NXP MCIMX93-EVK
- Link: File:NXP MCIMX93-EVK M33 TestProject ES V810.zip