Difference between revisions of "GigaDevice GD32L235R-EVAL"
(Created page with "Category:Evalboards __TOC__ This article describes specifics for the GigaDevice GD32L235R-EVAL evaluation board. 450px ==...") |
(No difference)
|
Revision as of 13:46, 13 June 2024
Contents
This article describes specifics for the GigaDevice GD32L235R-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the pins as seen in the image below:
- Power the board via usb power supply
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L233R-EVAL. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.67c
- Embedded Studio: V6.22a
- Hardware: GigaDevice GD32L233R-EVAL
- Link: File:GigaDevice GD32L233R-EVAL TestProject ES V622a.zip
