Difference between revisions of "Microchip PIC32CX BZ2"
(Created page with "800px|thumb|right|Microchip WBZ450 Curiosity evaluation board This article describes specifics for the Microchip WBZ450 Curiosity...") |
(No difference)
|
Revision as of 15:41, 19 June 2024
This article describes specifics for the Microchip WBZ450 Curiosity evaluation board. It can be used to test & verify Microchip PIC32CX-BZ2 device support.
Minimum requirements
- J-Link software V7.96m or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J10).
- Power the board via the USB jack of the break out board (J7).
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Microchip WBZ450 Curiosity. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96m
- Embedded Studio: V8.12a
- Hardware: Microchip WBZ450 Curiosity
- Link: File:Microchip WBZ450 Curiosity TestProject ES 8V12a.zip