Difference between revisions of "NXP FRDM-MCXC242"
(Created page with "Category:Evalboards __TOC__ This article describes specifics for the FRDM-MCXC242 evaluation board.<br> 450px == Preparing fo...") |
(No difference)
|
Revision as of 09:43, 26 June 2024
This article describes specifics for the FRDM-MCXC242 evaluation board.
Preparing for J-Link
- Connect the J-Link to J10.
- Power the board via J9.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the FRDM-MCXC242
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V7.20
- Hardware: NXP FRDM-MCXC242
- Link: File:NXP MCXC242 TestProject ES 7V20.zip
