Difference between revisions of "Renesas EK-RA6M4"
(Created page with "__TOC__ This article describes specifics for the Renesas EK-RA6M4 evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Pr...") |
(No difference)
|
Revision as of 14:24, 27 June 2024
This article describes specifics for the Renesas EK-RA6M4 evaluation board.
[PICTURE OF BOARD]
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M4.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Renesas EK-RA6M4
- Link: File:Renesas R7FA6M4F3 TestProject ES V810b.zip