Difference between revisions of "Renesas EK-RA4M2"
(Created page with " __TOC__ This article describes specifics for the Renesas EK-RA4M2 evaluation board.<br> 450px == Preparing for J-Link == *C...") |
(→Preparing for J-Link) |
||
Line 7: | Line 7: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to this pins: |
+ | {| class="seggertable" |
||
− | *Power the board via J10. |
||
+ | |- |
||
+ | ! J-Link Pin || Connector !! Pin || Name |
||
+ | |- |
||
+ | | VTref || J4 || 1 || +3V3 |
||
+ | |- |
||
+ | | GND || J4 || 27 || GND |
||
+ | |- |
||
+ | | TMS/SWDIO || J3 || 3 || P108 |
||
+ | |- |
||
+ | | TCK/SWCLK || J4 || 26 || P300 |
||
+ | |} |
||
+ | *Power the board via J11. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:Renesas_R7FA6M3AH_EK-RA4M2_connect.png|400px]] |
[[File:Renesas_R7FA6M3AH_EK-RA4M2_connect.png|400px]] |
||
+ | |||
== Example Project== |
== Example Project== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA4M2.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA4M2.<br>It is a simple Hello World sample linked into the internal flash.<br> |
Revision as of 15:58, 28 June 2024
This article describes specifics for the Renesas EK-RA4M2 evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | J4 | 1 | +3V3 |
GND | J4 | 27 | GND |
TMS/SWDIO | J3 | 3 | P108 |
TCK/SWCLK | J4 | 26 | P300 |
- Power the board via J11.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA4M2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V8.10b
- Hardware: Renesas EK-RA4M2
- Link: File:Renesas R7FA6M3AH TestProject ES V810b.zip