Difference between revisions of "WSL"
Line 8: | Line 8: | ||
== Example setup with USB == |
== Example setup with USB == |
||
− | In this example we will connect to our J-Link (connected via USB) from WSL using the [[J-Link_Remote_Server | J-Link Remote Server ]] on the host side and the [[J-Link_Commander | J-Link Commander]] |
+ | In this example we will connect to our J-Link (connected via USB to the host) from WSL using the [[J-Link_Remote_Server | J-Link Remote Server ]] on the host side and the [[J-Link_Commander | J-Link Commander]] |
on the WSL side. |
on the WSL side. |
||
Revision as of 15:17, 27 April 2020
Windows subsystem for Linux (WSL) is a part of Windows 10, that allows the user to run Linux applications on Windows.
J-Link specifics
As of now WSL does not fully support USB devices.
In order to connect to a J-Link from WSL you either have to use the Ethernet / WiFi interface (if present, see Model overview) or make use of the J-Link Remote Server that runs on an another machine, capable of USB.
Example setup with USB
In this example we will connect to our J-Link (connected via USB to the host) from WSL using the J-Link Remote Server on the host side and the J-Link Commander on the WSL side.
Requirements
- Windows 10 system which has the J-Link Software and Documentation Pack installed
- WSL system which has the J-Link Software and Documentation Pack installed
- J-Link connected via USB to the host Windows 10 system
Steps
- Start the J-Link Remote Server in LAN mode on the Windows 10 host system.
- Switch to the command-line prompt of your WSL Linux system
- Set the target device and interface in the following command and execute it:
JLinkExe -device <your-device> -ip localhost -if <target-interface> -speed 4000 -autoconnect 1