Difference between revisions of "NXP NHS52Sxx EVK"
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
[[File:NXP_NHS52Sxx_EVK.jpg|450px|thumb|right]] |
[[File:NXP_NHS52Sxx_EVK.jpg|450px|thumb|right]] |
||
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. |
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. |
||
It comes with an [[NXP_NHS52S | NXP NHS52S04]] MCU mounted. |
It comes with an [[NXP_NHS52S | NXP NHS52S04]] MCU mounted. |
||
__TOC__ |
__TOC__ |
||
| − | <br clear="all"> |
||
== Minimum requirements == |
== Minimum requirements == |
||
| Line 45: | Line 45: | ||
*Embedded Studio: V6.34a |
*Embedded Studio: V6.34a |
||
*Hardware: NXP NHS52Sxx_EVK |
*Hardware: NXP NHS52Sxx_EVK |
||
| − | *Link: [[ |
+ | *Link: [[Media:NXP_NHS52S04_TestProject.zip | NXP_NHS52S04_TestProject.zip]] |
Latest revision as of 15:33, 8 May 2024
This article describes specifics for the NXP NHS52Sxx_EVK evaluation board. It comes with an NXP NHS52S04 MCU mounted.
Contents
Minimum requirements
- J-Link software V7.80 or later.
Preparing for J-Link
The board can be powered via the USB_PWR USB slot.
For jumper configuration see: Jumper configuration.
The J-Link can be connected via the J11 SWD port, e.g. using the SEGGER 9-Pin Cortex-M Adapter.
- Verify the Connection with e.g. J-Link Commander.
The output should look as follows:
Jumper configuration
J-Link support was tested with the following jumper selection (as marked as in the picture above).
| Jumper | Selection |
|---|---|
| J3 | 1-2 (3V) |
| J4 | USB |
| J9 | 1-2 |
| J10 | 1-2 |
| J28 | 1-2 |
| J30 | 1-2 |
| J36 | 1-2 & 3-4 |
| Other | NOT SET |
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP NHS52Sxx_EVK. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.80
- Embedded Studio: V6.34a
- Hardware: NXP NHS52Sxx_EVK
- Link: NXP_NHS52S04_TestProject.zip
