Difference between revisions of "Mindmotion PLUS5270 MM32F5270"
(3 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the Mindmotion PLUS5270 MM32F5270 evaluation board. |
This article describes specifics for the Mindmotion PLUS5270 MM32F5270 evaluation board. |
||
− | [[File: |
+ | [[File:MM_PLUS5270_MM32F5270_Board.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
− | * J-Link software |
+ | * J-Link software V7.82b or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Line 19: | Line 20: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: |
+ | *J-Link software: V7.82b |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion PLUS5270 MM32F5270 |
*Hardware: Mindmotion PLUS5270 MM32F5270 |
Latest revision as of 15:34, 8 May 2024
This article describes specifics for the Mindmotion PLUS5270 MM32F5270 evaluation board.
Minimum requirements
- J-Link software V7.82b or later
Preparing for J-Link
- Connect the J-Link to the SWD header (P15)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82b
- Embedded Studio: V6.34
- Hardware: Mindmotion PLUS5270 MM32F5270
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip