Difference between revisions of "Nuvoton-NuMaker-M071MD"
(4 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
||
− | [[File:Nuvoton-NuMaker-M071MD-Picture.jpg| |
+ | [[File:Nuvoton-NuMaker-M071MD-Picture.jpg|600px]] |
− | |||
− | |||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link |
+ | *Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10 |
− | *Power the board via |
+ | *Power the board via J2 or ICE J3 |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:Nuvoton_NuMaker-M071MD_M071MD2AE_Connect.png|400px]] |
[[File:Nuvoton_NuMaker-M071MD_M071MD2AE_Connect.png|400px]] |
Latest revision as of 15:00, 15 May 2024
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
- Power the board via J2 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M071MD
- Link: File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip