Difference between revisions of "ST STM32H573I-DK"
(→Example Project) |
|||
Line 1: | Line 1: | ||
+ | _[[Category:Evalboards]] |
||
− | __TOC__ |
||
+ | _TOC__ |
||
This article describes specifics for the '''ST STM32H573I-DK''' evaluation board.<br> |
This article describes specifics for the '''ST STM32H573I-DK''' evaluation board.<br> |
Latest revision as of 12:15, 16 May 2024
_ _TOC__
This article describes specifics for the ST STM32H573I-DK evaluation board.
Preparing for J-Link
- On the back side of the board close jumper J1 so that the board can be accessed with an external debug connector.
- Connect the J-Link to the 10 pin debug connector CN12 which is located on the backside of the board.
- On the display side of the board set jumper JP4 to 3-4 (USB-PD) for power via USB-C (CN17).
- Power the board via USB-C (CN17).
The result should look like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H573I-DK.
It is a simple Hello World sample linked into the internal flash.
Setup
- J-Link software: V7.86c
- Embedded Studio: V7.10
- Hardware: ST STM32H573I-DK
- Link: File:ST STM32H573I-DK HelloWorld.zip