Difference between revisions of "ST NUCLEO-F042K6"
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 8: | Line 9: | ||
*Power the board via CN1 (Micro USB) |
*Power the board via CN1 (Micro USB) |
||
− | * |
+ | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File:.PNG|400px]] |
+ | [[File:STM32F04K6_con.PNG|400px]] |
== Example Project== |
== Example Project== |
||
Line 18: | Line 19: | ||
*J-Link software: V7.90 |
*J-Link software: V7.90 |
||
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
− | *Hardware: ST NUCLEO- |
+ | *Hardware: ST NUCLEO-F042K6 |
− | *Link: [[File:.zip]] |
+ | *Link: [[File:STM32F04K6_Projekt.zip]] |
Latest revision as of 11:30, 15 May 2024
This article describes specifics for the ST NUCLEO-F042K6 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Micro USB)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F042K6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F042K6
- Link: File:STM32F04K6 Projekt.zip