Difference between revisions of "NUCLEO-F207ZG"
(Created page with "__TOC__ This article describes specifics for the ST STM3210C-EVAL evaluation board.<br> 400px == Preparing for J-Link == *Power the board via...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 6: | Line 7: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Power the board via |
+ | *Power the board via Mini USB (CN1) |
+ | *Reflash the ST-LINK On-Board Into a J-Link [https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/ Guide] |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:STMNUCLEO-F207ZG_con.PNG|400px]] |
[[File:STMNUCLEO-F207ZG_con.PNG|400px]] |
||
− | *Note select device: " |
+ | *Note select device: "STM32F207ZG". |
== Example Project== |
== Example Project== |
Latest revision as of 11:32, 15 May 2024
This article describes specifics for the ST STM3210C-EVAL evaluation board.
Preparing for J-Link
- Power the board via Mini USB (CN1)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32F207ZG".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-F207ZG.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.90
- Embedded Studio: V7.20
- Hardware: ST NUCLEO-F207ZG
- Link: File:NUCLEO-F207ZG Projekt.zip