Difference between revisions of "NXP LPCXpresso860-MAX"
| (One intermediate revision by the same user not shown) | |||
| Line 11: | Line 11: | ||
== Example Project== |
== Example Project== |
||
TBD |
TBD |
||
| + | --> |
||
<!-- |
<!-- |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP LPCXpresso860-MAX.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP LPCXpresso860-MAX.<br> |
||
| Line 19: | Line 20: | ||
*Embedded Studio: V7.10a |
*Embedded Studio: V7.10a |
||
*Link: [[File:VENDOR_DEVICENAME_TestProject_ES_V452b.zip]] |
*Link: [[File:VENDOR_DEVICENAME_TestProject_ES_V452b.zip]] |
||
| − | --> |
||
Latest revision as of 10:40, 20 September 2023
This article describes specifics for the NXP LPCXpresso860-MAX evaluation board.
Contents
Preparing for J-Link
- Connect the J-Link to J7 using the 9-Pin Cortex-M Adapter
- Power the board via micro USB (J4)
- Verify the Connection with e.g. with J-Link Commander. The output should look as follows:
Example Project
TBD -->
