Difference between revisions of "NXP MCX-N9XX-BRK"
(2 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 8: | Line 9: | ||
*Power the board via USB J3. |
*Power the board via USB J3. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:NXP_FRDM-MCXN947_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Line 14: | Line 15: | ||
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.94c |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: NXP MCX-N9XX-BRK |
*Hardware: NXP MCX-N9XX-BRK |
Latest revision as of 13:19, 15 May 2024
This article describes specifics for the NXP MCX-N9XX-BRK evaluation board.
Preparing for J-Link
- Connect the J-Link to J4.
- Power the board via USB J3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-N9XX-BRK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94c
- Embedded Studio: V6.34
- Hardware: NXP MCX-N9XX-BRK
- Link: File:NXP MCXN947 TestProject ES V634.zip