Difference between revisions of "Renesas RA2A2"
(→Evaluation Boards) |
|||
(4 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Device families]] |
||
The '''Renesas RA2A2''' are Cortex-M23 based microcontrollers. |
The '''Renesas RA2A2''' are Cortex-M23 based microcontrollers. |
||
__TOC__ |
__TOC__ |
||
Line 29: | Line 30: | ||
On disconnect, the J-Link restores device specific settings which are required to support low power mode debugging but may result in an increased power consumption if not disabled. |
On disconnect, the J-Link restores device specific settings which are required to support low power mode debugging but may result in an increased power consumption if not disabled. |
||
==Evaluation Boards== |
==Evaluation Boards== |
||
+ | *[[Renesas EK-RA2A2|Renesas EK-RA2A2]] |
||
− | *[[WikiTemplateEvalBoard|[SiliconVendor] [EvalBoardName]]] |
||
+ | |||
==Example Application== |
==Example Application== |
||
− | *[[ |
+ | *[[Renesas EK-RA2A2#Example_Project|Renesas EK-RA2A2]] |
Latest revision as of 13:26, 15 May 2024
The Renesas RA2A2 are Cortex-M23 based microcontrollers.
Contents
Internal Flash
Flash Bank | Base address | Size | J-Link Support | Loaders |
---|---|---|---|---|
Program flash | 0x00000000 | Up to 32 KB |
| |
Data flash | 0x40100000 | 8 KB |
| |
Program flash option-setting memory | 0x01010008 | 44 B |
|
NOTE:The device has an Independent Watchdog Timer (IWDT) which is fed during flash programming.
Device Specific Handling
Connect
- Authentication via IDCODE is supported
- Wake-up CPU from low-power mode is supported
- Connect under reset is supported
Reset
- The devices uses normal Cortex-M reset, no special handling necessary, like described here.
Disconnect
On disconnect, the J-Link restores device specific settings which are required to support low power mode debugging but may result in an increased power consumption if not disabled.