Difference between revisions of "Nuvoton-NuMaker-M071MD"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> '''[PICTURE OF BOARD]''' == Preparing for J-Link == *Connect the J-Link to .....")
 
Line 2: Line 2:
   
 
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br>
 
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br>
  +
[[File:Nuvoton-NuMaker-M071MD-Picture.jpg]]
'''[PICTURE OF BOARD]'''
 
   
   

Revision as of 19:35, 16 January 2023

This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Nuvoton-NuMaker-M071MD-Picture.jpg


Preparing for J-Link

  • Connect the J-Link to ......
  • Power the board via........
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

[PICTURE OF CONNECT]

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.

SETUP

  • J-Link software: V6.74
  • Embedded Studio: V4.52b
  • Hardware: [SiliconVendor] [EvalBoardName]
  • Link: [[]]