Difference between revisions of "Nuvoton-NuMaker-M071MD"
Line 7: | Line 7: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link : VTref=J1-2 / |
+ | *Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10 |
*Power the board via J3 or ICE J3 |
*Power the board via J3 or ICE J3 |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
Revision as of 19:54, 16 January 2023
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
- Power the board via J3 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M071MD
- Link: File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip