Difference between revisions of "Nuvoton-NuMaker-M071MD"
| Line 3: | Line 3: | ||
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
||
[[File:Nuvoton-NuMaker-M071MD-Picture.jpg|400px]] |
[[File:Nuvoton-NuMaker-M071MD-Picture.jpg|400px]] |
||
| − | |||
| − | |||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Revision as of 19:55, 16 January 2023
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
- Power the board via J3 or ICE J3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: Nuvoton NuMaker-M071MD
- Link: File:Nuvoton_NuMaker-M071MD_M071MD2AE_TestProject_ES_V634.zip
