Difference between revisions of "Renesas EK-RA6E2"
(Created page with "__TOC__ This article describes specifics for the Renesas EK-RA6E2 evaluation board.<br> 450px == Preparing for J-Link == *Connect the J-Link to J...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the Renesas EK-RA6E2 evaluation board.<br> |
This article describes specifics for the Renesas EK-RA6E2 evaluation board.<br> |
Latest revision as of 13:32, 15 May 2024
This article describes specifics for the Renesas EK-RA6E2 evaluation board.
Preparing for J-Link
- Connect the J-Link to J13
- Power the board via USB
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6E2.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34
- Hardware: Renesas EK-RA6E2
- Link: File:Renesas EK-RA6E2 TestProject ES V634.zip