Difference between revisions of "NXP RD-RW616-BGA IPA-2A/1A"
(→Preparing for J-Link) |
(→SETUP) |
||
Line 14: | Line 14: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: |
+ | *J-Link software: V7.92c |
− | *Embedded Studio: |
+ | *Embedded Studio: V7.20 |
*Hardware: NXP RD-RW616-BGA_IPA-2A/1A |
*Hardware: NXP RD-RW616-BGA_IPA-2A/1A |
||
− | *Link: [[File: |
+ | *Link: [[File:NXP_RW61x_TestProject_ES_7V20.zip]] |
Revision as of 15:44, 24 August 2023
This article describes specifics for the NXP RD-RW616-BGA_IPA-2A/1A evaluation board.
Preparing for J-Link
- Connect the J-Link to P2
- Power the board via J1
- Jumper JP1 must be set in order to use J-Link
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92c
- Embedded Studio: V7.20
- Hardware: NXP RD-RW616-BGA_IPA-2A/1A
- Link: File:NXP RW61x TestProject ES 7V20.zip