Difference between revisions of "ESWIN EMU32VL170 TEST BRD"
(→Preparing for J-Link) |
|||
| Line 13: | Line 13: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
| − | *J-Link software: V7. |
+ | *J-Link software: V7.92h |
*Embedded Studio: V7.20 |
*Embedded Studio: V7.20 |
||
| − | *Hardware: |
+ | *Hardware: ESWIN EMU32VL170 TEST BRD |
| − | *Link: [[File: |
+ | *Link: [[File:ESWIN_EMU32Vl170._TestProject_ES_7V20.zip]] |
Revision as of 08:52, 28 September 2023
This article describes specifics for the ESWIN EMU32VL170 TEST BRD evaluation board.
Preparing for J-Link
- Connect the J-Link to J88.
- Power the board via J91.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92h
- Embedded Studio: V7.20
- Hardware: ESWIN EMU32VL170 TEST BRD
- Link: File:ESWIN EMU32Vl170. TestProject ES 7V20.zip
