Difference between revisions of "Renesas EK-RA8D1"
(Created page with "__TOC__ This article describes specifics for the Renesas EK-RA8D1 evaluation board. For device specifics, please see Renesas RA8D1.<br> [[File:Renesas_EK-RA8D1.jpg|450px]...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Revision as of 11:49, 16 May 2024
This article describes specifics for the Renesas EK-RA8D1 evaluation board. For device specifics, please see Renesas RA8D1.
Preparing for J-Link
- Power the board via J10 (Micro USB)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA8D1.
It is a simple counter linked into the internal code flash.
SETUP
- J-Link software: V7.92l
- Embedded Studio: V7.20
- Hardware: Renesas EK-RA8D1
- Link: File:Renesas EK-RA8D1 TestProject ES V720.zip