Difference between revisions of "NXP 8MMINILPD4-EVKB"
Line 26: | Line 26: | ||
*Embedded Studio: V8.10 |
*Embedded Studio: V8.10 |
||
*Hardware: NXP 8MMINILPD4-EVKB |
*Hardware: NXP 8MMINILPD4-EVKB |
||
− | *Link: [[File: |
+ | *Link: [[File:NXP_8MMINILPD4_EVKB_M4_TestProject_ES_8V10.zip]] |
Revision as of 09:43, 5 April 2024
This article describes specifics for the NXP 8MMINILPD4-EVKB evaluation board. It can be used to test & verify NXP iMX 8M Mini device support for Cortex-M4.
Minimum requirements
- J-Link software V7.94 or later
- The board should have a bootloader(U-Boot) image on one of the available boot device
Preparing for J-Link
- Connect the J-Link to JTAG connector (J902).
- Connect the onboard USB-UART debug interface to host computer (J901).
- Open a serial interface communication via terminal application(PuTTY).
- Power the board via USB Type-C Power connector (J302).
- Turn on the power switch (SW101).
- Wait until the bootloader is started and interrupt the loading of the operating system(Linux Kernel). The output should look as follows:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP 8MMINILPD4-EVKB.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94
- Embedded Studio: V8.10
- Hardware: NXP 8MMINILPD4-EVKB
- Link: File:NXP 8MMINILPD4 EVKB M4 TestProject ES 8V10.zip