Difference between revisions of "GigaDevice GD32105C-EVAL"
(→Preparing for J-Link) |
(→Example Project) |
||
Line 11: | Line 11: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32105C-EVAL .<br>It is a simple Hello World sample linked into the internal flash.<br> |
====SETUP==== |
====SETUP==== |
||
*Embedded Studio: V8.10b |
*Embedded Studio: V8.10b |
||
− | *Hardware: GigaDevice |
+ | *Hardware: GigaDevice GD32105C-EVAL |
*Link: [[File:GigaDevice_GD32F105VC_TestProject_ES_V810b.zip]] |
*Link: [[File:GigaDevice_GD32F105VC_TestProject_ES_V810b.zip]] |
Revision as of 15:12, 5 April 2024
This article describes specifics for the GigaDevice GD32105C-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (JP1)
- Power the board via CN2.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32105C-EVAL .
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32105C-EVAL
- Link: File:GigaDevice GD32F105VC TestProject ES V810b.zip