Difference between revisions of "GigaDevice GD32E232K-START"
(→Preparing for J-Link) |
(→Preparing for J-Link) |
||
Line 11: | Line 11: | ||
! J-Link Pin || Connector !! Pin || Name |
! J-Link Pin || Connector !! Pin || Name |
||
|- |
|- |
||
− | | VTref || JP3 || 1 || |
+ | | VTref || JP3 || 1 || 3V3 |
|- |
|- |
||
| GND || JP3 || 4 || GND |
| GND || JP3 || 4 || GND |
Latest revision as of 16:43, 7 June 2024
This article describes specifics for the GigaDevice GD32E232K-START evaluation board.
Preparing for J-Link
- Connect the J-Link to this pins:
J-Link Pin | Connector | Pin | Name |
---|---|---|---|
VTref | JP3 | 1 | 3V3 |
GND | JP3 | 4 | GND |
TMS/SWDIO | JP3 | 2 | IO |
TCK/SWCLK | JP3 | 3 | CK |
- Power the board via CN100.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E232K-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- Embedded Studio: V8.10b
- Hardware: GigaDevice GD32E232K-START
- Link: File:GigaDevice GD32E232K8 TestProject ES V810b.zip