Difference between revisions of "TM4C123G LaunchPad"
(Created page with "The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe, like the J-Link, at the first, t...") |
|||
Line 1: | Line 1: | ||
− | The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe |
+ | The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe like the J-Link, at the first, the Tiva C Series TM4C123G LaunchPad board needs to be manually setup: |
− | * Solder a |
+ | * Solder a strip header to DBG (see image below) |
− | * Connect the debug interface signals manually (e.g. using jumping wires) as |
+ | * Connect the debug interface signals manually (e.g. using jumping wires) as described in the table below |
+ | <table> |
||
− | |||
+ | <tr> |
||
+ | <td valign="top">[[File:wiki-board-TM4C123G-LaunchPad.png|500px]]</td> |
||
+ | <td valign="top"></td> |
||
+ | <td valign="top"> |
||
{| class="wikitable" |
{| class="wikitable" |
||
|- |
|- |
||
Line 21: | Line 25: | ||
| GND || Pin 4 (GND) |
| GND || Pin 4 (GND) |
||
|} |
|} |
||
+ | </td> |
||
− | |||
+ | </tr> |
||
− | |||
+ | </table> |
||
− | [[File:wiki-board-TM4C123G-LaunchPad.png]] |
Revision as of 10:40, 23 May 2016
The TI TM4C123G LaunchPad evaluation board does not come with an external debug connector. Therefore, in order to use an external debug probe like the J-Link, at the first, the Tiva C Series TM4C123G LaunchPad board needs to be manually setup:
- Solder a strip header to DBG (see image below)
- Connect the debug interface signals manually (e.g. using jumping wires) as described in the table below
|