Difference between revisions of "Nations N32G032R8L7 STB"

From SEGGER Wiki
Jump to: navigation, search
Line 9: Line 9:
   
 
== Preparing for J-Link ==
 
== Preparing for J-Link ==
*Connect the J-Link : VTref= J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
+
*Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
 
*Power the board via USB (J4)
 
*Power the board via USB (J4)
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:

Revision as of 15:08, 13 December 2022

This article describes specifics for the Nations N32G032R8L7_STB evaluation board.

450px

Minimum requirements

  • J-Link software V7.82g or later

Preparing for J-Link

  • Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
  • Power the board via USB (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G032R8L7_STB N32G032R8L7.
It is a simple Hello World sample linked into the internal flash.

SETUP

  • J-Link software: V7.82g
  • Embedded Studio: V6.34
  • Hardware: N32G032R8L7_STB
  • Link: File:.zip