Difference between revisions of "Nuvoton NuMaker-M263KI"
Line 9: | Line 9: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link |
+ | *Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6 |
− | *Power the board via |
+ | *Power the board via J2 (USB OTG) or ICEJ3 |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:|400px]] |
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI. <br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.84b |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
− | *Hardware: |
+ | *Hardware: Nuvoton NuMaker-M263KI |
*Link: [[File:GigaDevice_GD32A503V-EVAL_GD32A503VD.zip]] |
*Link: [[File:GigaDevice_GD32A503V-EVAL_GD32A503VD.zip]] |
Revision as of 18:07, 9 January 2023
This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
- Power the board via J2 (USB OTG) or ICEJ3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[[File:|400px]]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.84b
- Embedded Studio: V6.34
- Hardware: Nuvoton NuMaker-M263KI
- Link: File:GigaDevice GD32A503V-EVAL GD32A503VD.zip