Difference between revisions of "Nuvoton NuMaker-M263KI"
| Line 22: | Line 22: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Nuvoton NuMaker-M263KI |
*Hardware: Nuvoton NuMaker-M263KI |
||
| − | *Link: [[File: |
+ | *Link: [[File:Nuvoton_NuMaker-M263KI_M263KIAAE_TestProject_ES_V634.zip]] |
Revision as of 18:15, 9 January 2023
This article describes specifics for the Nuvoton NuMaker-M263KI evaluation board.
Minimum requirements
- J-Link software V7.84b or later
Preparing for J-Link
- Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
- Power the board via J2 (USB OTG) or ICEJ3
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[[File:|400px]]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.84b
- Embedded Studio: V6.34
- Hardware: Nuvoton NuMaker-M263KI
- Link: File:Nuvoton NuMaker-M263KI M263KIAAE TestProject ES V634.zip
