Difference between revisions of "Nuvoton-NuMaker-M071MD"
Line 2: | Line 2: | ||
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.<br> |
||
− | [[File:Nuvoton-NuMaker-M071MD-Picture.jpg]] |
+ | [[File:Nuvoton-NuMaker-M071MD-Picture.jpg|400px]] |
Revision as of 19:37, 16 January 2023
This article describes specifics for the Nuvoton NuMaker-M071MD evaluation board.
Preparing for J-Link
- Connect the J-Link to ......
- Power the board via........
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: [[]]