Difference between revisions of "Mindmotion Mini-F5233-MM32F5233D7P"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board. 450px == Minimum requirements...")
 
Line 3: Line 3:
 
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
 
This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.
   
[[File:MM_PLUS5270_MM32F5270_Board.jpg|450px]]
+
[[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_board.jpg|450px]]
   
 
== Minimum requirements ==
 
== Minimum requirements ==
* J-Link software V7.82b or later
+
* J-Link software V7.92d or later
   
 
== Preparing for J-Link ==
 
== Preparing for J-Link ==
Line 13: Line 13:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
   
[[File:MM_PLUS5270_MM32F5270_Connect.png|400px]]
+
[[File:MindMotion_MB-085-Mini-F5233_MM32F5233D7PV_connect|400px]]
   
 
== Example Project==
 
== Example Project==

Revision as of 08:33, 7 September 2023

This article describes specifics for the Mindmotion Mini-F5233 MM32F5233D7P evaluation board.

450px

Minimum requirements

  • J-Link software V7.92d or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (P15)
  • Power the board via external power supply / power jack (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.

SETUP